JADODE Front LH or RH Manual Hub Lock for 2005-2017 2018 Ford F250 F350 Super Duty
Subcribe to back in stock notification
Free Shipping
FREE Standard Shipping | Located in: United States
Returns
30 days returns | Seller pays for return shipping
- Fits LH (Driver Side) Or RH (Passenger Side)
- Fits 4WD (Four Wheel Drive) Models with Manual Locking Hubs only
- THIS PART REPLACES:
- Ford OEM BC3Z3B396B
- OE # BC3Z3B396B
Fitment
- For 2005-2018 Ford F-250 Super Duty
- For 2005-2018 Ford F-350 Super Duty
- For 2005-2018 Ford F-450 Super Duty
- For 2005-2018 Ford F-550 Super Duty
- Remove the center cap using a pry bar or screwdriver
- Remove the snap ring from the hub
- Pull the hub out
- If the hub is stuck spray it with penetrating oil and let it sit for a while
- Hit it with a rubber mallet from the top and bottom until it loosens and pull it free
- Clean the inside of the hub with a wire brush
- If available use compressed air to spray out the debris
- Push the new hub into place
- Use a rubber mallet to help the O-ring seat
- Put the snap ring on
- Replace the center cap
- 2 x Front Manual Locking Hub
Shipping, Returns & Fitment
Before ordering a vehicle- or trailer-specific part, verify the year, make, model, engine, drivetrain, installation position, axle rating, bolt pattern, bearing numbers, and any OEM or interchange number shown in the listing.
Review our Shipping & Returns information and Refund Policy before purchase. For an RMA, fitment question, or return involving an installed part, contact Jaautousa support before shipping the item back.
Fitment, Installation & Returns
Confirm every applicable specification before ordering. A matching vehicle family or axle capacity alone does not guarantee fitment.
- Review the Jaautousa fitment and ordering checklist
- Review routine vehicle maintenance and safety basics
- Read Shipping & Returns information
- Review the Refund Policy and return-fitment rules
- Contact Jaautousa before ordering if fitment is uncertain
Safety: Use the product instructions and vehicle or equipment manufacturer specifications. Have braking, towing, electrical, suspension, and load-bearing work inspected by a qualified professional when required.
