JADODE For 2004 - 2014 Ford F-150 F150 Parts IWE 4WD Auto Hub Lock Actuator
Free Shipping
FREE Standard Shipping | Located in: United States
Returns
30 days returns | Seller pays for return shipping
Specifications:
- Comes as a PAIR
- Fits both LH (Driver Side) & RH (Passenger Side) FRONT
- Replaces dealer part number: 7L1Z-3C247-A, 7L1Z3C247
- Direct replacements
- Built to strict quality control standards
Fits:
- 2003-2015 Ford Expedition 4WD
- 2015 Ford Expedition AWD
- 2004-2015 Ford F-150 4WD
- 2008-2012 Ford F-150 AWD
- 2006-2008 Lincoln Mark LT 4WD
- 2006-2014 Lincoln Mark LT AWD
- 2003-2015 Lincoln Navigator 4WD
- 2005-2015 Lincoln Navigator AWD
Installation Instructions
-
STEP 1: RAISE AND SECURE THE VEHICLE
- Raise the vehicle with a jack
- Secure the vehicle on jack stands
-
STEP 2: REMOVING THE CV AXLE SHAFT
- Remove the cap over the hub nut
- Pry off the wheel center cap with a flat blade screwdriver
- Remove the 13mm hub nut
- While holding the tire in place, remove the six twelve-point 12mm bolts from the CV joint
- Remove the 30mm bolt from the strut assembly using a breaker bar or ratchet and pipe
- Tap the nut with a hammer to loosen it, if necessary
- Pry the lower end of the strut assembly from the lower control arm with a pry bar
- Pull out the CV shaft
-
STEP 3: REMOVING THE FOUR WHEEL DRIVE ACTUATOR
- Pry off the actuator with a flat blade screwdriver
- Remove the three 8mm bolts from the four wheel drive actuator
- Disconnect the vacuum hoses from the actuator
-
STEP 4: INSTALLING THE NEW ACTUATOR
- Put the actuator into place
- Connect the vacuum hoses to the new actuator
- Start the three 8mm bolts by hand
- Tighten the three 8mm bolts
-
STEP 5: REATTACHING THE CV AXLE
- Reconnect the strut at the lower control arm
- Slide the CV Axle back into place
- Push the bolt through where the strut connects to the lower control arm
- Attach the nut
- Tighten the bolt to between 95-100 foot-pounds of torque
- Start the 12-point 12mm bolts into the CV axle by hand
- Tighten the bolts preliminarily
- Tighten the bolts to 25 foot-pounds in a crossing or star pattern
- Reinstall the 13mm nut on the end of the axle
- Reinstall the cap over the nut
- Reinstall the center cap
- Lower the vehicle
Shipping Policy
Item location:United States
Ships to: United States
If you have any questions, please contact our customer service folks. comi@autousa.com
RETURNS POLICY
After receiving the item, contact seller within 30 days, and seller pays for return shipping.
We do not accept returned products that have already been installed, please contact customer service for replacement or refunds All returns must include the following:
1.Original packaging (manufacturer's box, plastic bags, etc.)
2.Valid Return Merchandise Authorization (RMA)
3.All accessories (lubricant, stickers, installation instructions)
4.Manufacturer documentation (manuals, warranty cards, registration information, etc.)
5.The RMA number must not be written on the original manufacturer's packaging or box. Please write the RMA number on the label used to return the item or the return shipping box. Items received with any writing on the original manufacturer's packaging or box will be refused and returned to you at your cost and without credit approval.
